Answer:
Hydroelectric pumped storage can be used to eliminate the conditional nature of wind and solar energy. At times of peak production of energy from either solar or wind (during summer and windy days), the excess electrical energy produced can be stored using hydroelectric pumped storage methods. When conditions no longer favour energy production from either wind or solar sources, these stored energy can then be regenerated for use.
Explanation:
Pumped-storage hydroelectricity is a type of hydroelectric energy storage used by electric power systems to store excess electrical power during periods of low demand for later release at periods when demand for energy rises again. It stores energy in the form of gravitational potential energy of water, pumped from a lower level reservoir to a higher level reservoir.
At times of low electrical demand, excess generated energy is used to pump water into the upper reservoir. When there is higher demand, water is released back into the lower reservoir through a turbine, generating electricity.
This form of energy storage is useful in circumventing the conditional nature of renewable energy sources such as wind and solar energy. At times of peak production of energy from either solar or wind (during summer and windy days), the excess electrical energy produced can be stored using hydroelectric pumped storage methods. When conditions no longer favour energy production from either wind or solar sources, these stored energy can then be regenerated for use.
what is the difference between isotopes and allotrope not more than three line
Answer:
An allotrope is one way that atoms can be arranged in a solid. An isotope is one way that protons and neutrons can form the same atomic element.
Where do we get our energy from ?
Answer:
energy
Explanation:
Nitrous acid is classified as an Arrhenius acid because HNO2 contains
1. OH-ions
2. 02-ions
3. NO2-ions
4. H+ ions
4) H+ions is your answer , good morning , have a great day ahead.
In an exothermic the change in enthalpy is usually
Positive, because the potential energy of the reactants is higher than the potential energy of the products
Neutral, because the potential energy of the products and reactants cancel each other out.
Negative, because the potential energy of the reactants is higher than the potential energy of the products
Positive, because the potential energy of the reactants is lower than the potential energy of the products
Answer:
Negative, because the potential energy of the reactants is higher than the potential energy of the products
Explanation:
Exothermic reaction is a reaction in which heat is released to surrounding. This is due to the fact that the heat content of the reactant is higher than the heat content of product thus producing a negative enthalpy change (ΔH) i.e
Enthalpy change = Heat of product – Heat of reactant
ΔH = Hp – Hr = negative
Considering the options given in the question above, the correct answer is:
Negative, because the potential energy of the reactants is higher than the potential energy of the products
8. Of what importance is a smoker to a person keeping bees?
Answer:
they help to calm the bees when the person keeping the bees inspects there hives.
What is the percent by mass concentration of 1000 ml of a solution (d=1.5 g/ml) that contains 50 g of solute in it?
Answer: The percent by mass concentration is 33.3 %
Explanation:
Mass percent is the ratio of mass of solute to the mass of solution in terms of percentage.
mass of solute = 50 g
mass of solution = [tex]{\text {density of solution}}\times {\text {volume of solution}}=1.5g/ml\times 1000ml=1500g[/tex]
Mass percentage = [tex]\frac{50g}{1500g}\times 100\%=33.3\%[/tex]
Thus percent by mass concentration of 1000 ml of a solution (d=1.5 g/ml) that contains 50 g of solute in it is 33.3 %
9) What is the density of the gold rock with a mass of 386 grams and has a volume of 20 cubic centimeters?
O 0.193 g/cc
O 193 g/cc
O 1.93 g/cc
19.3 g/cc
Answer:
density= mass/volume
hence density of gold rock
= 386/20
=19.3 g/cc
If I add 25mL of water to 125 mL of 0.25 M NaOH solution, what will the molarity of the diluted solution be?
Answer:
0.208333 M
Explanation:
M2=M1V1/V2=(0.25 M)(125mL)/(125mL+25 mL)= 0.208333 M
The acidic ingredient in vinegar is acetic acid. The pH of vinegar is around 2.4, and the molar concentration of acetic acid in vinegar is around 0.85 M. Based on this information, determine the value of the acid ionization constant, Ka, for acetic acid.
Answer: The value of acid ionization constant [tex]K_a[/tex] for acetic acid is [tex]1.87\times 10^{-5}[/tex]
Explanation:
[tex]CH_3COOH\rightarrow H^+CH_3COO^-[/tex]
cM 0 0
[tex]c-c\alpha[/tex] [tex]c\alpha[/tex] [tex]c\alpha[/tex]
So dissociation constant will be:
[tex]K_a=\frac{(c\alpha)^{2}}{c-c\alpha}[/tex]
Give c= 0.85 M and [tex]pH[/tex] = 2.4
[tex]pH=-log[H^+][/tex]
[tex][H^=}=c\times \alpha=10^{-2.4}=3.98\times 10^{-3}[/tex]
[tex]K_a=?[/tex]
Putting in the values we get:
[tex]K_a=\frac{(3.98\times 10^{-3})^2}{(0.85-3.98\times 10^{-3})}=1.87\times 10^{-5}[/tex]
Thus the value of acid ionization constant [tex]K_a[/tex] for acetic acid is [tex]1.87\times 10^{-5}[/tex]
4.What type of energy is used to fuel the process of photosynthesis and what type is produced in
respiration?
A Light energy is used in photosynthesis and created by respiration.
B ATP is used in photosynthesis, which allows the plant to undergo respiration.
C Light energy is used in photosynthesis, whereas respiration creates the energetic product, ATP.
D Food energy is used in photosynthesis and ATP is produced in respiration.
Answer:
A. light energy is used in photosynthesis and created by respiration
In a solution, litmus is blue. The pH of the solution could be
1. 10
2. 2
3. 3
4. 4
Answer:
1. 10
Explanation
when litmus paper is blue that means the solution is basic and 10 on the pH scale is the most basic out of all your options
How can I express the composition of a solution?
Answer:
It can be expressed in several ways: molarity (moles of solute per liter of solution); mole fraction, the ratio of the number of moles of solute to the total number of moles of substances present; mass percentage, the ratio of the mass of the solute to the mass of the solution times 100; parts per thousand (ppt), grams ...
Explanation:
It can be expressed in several ways: molarity (moles of solute per liter of solution); mole fraction, the ratio of the number of moles of solute to the total number of moles of substances present; mass percentage, the ratio of the mass of the solute to the mass of the solution times 100; parts per thousand (ppt), grams ...
How does every single cell in the body get the substances it needs to carry out the chemical reaction that provides it energy?