In the calorimeter, the heat received is the same as the heat released
Q abs = Q release
Heat can be calculated using the formula:
Q = mc∆T
Q = heat, J
m = mass, g
c = specific heat, joules / g ° C
∆T = temperature difference, ° C / K
Q released by a metallic ore and absorbed by water at calorimeter
Q ore = Q water
Q waterm = 0.5 kg = 500 g
c = 4.18 J/g–°C.
Δt = 24.3 - 22 = 2.3
[tex]\tt Q=m.c.\Delta t\\\\Q=500\times 4.18\times 2.3=4807~J[/tex]
the specific heat capacity of the ore.Q ore = Q water = 4807 J
m ore = 3.5 kg = 3500 g
Δt = 100 - 24.3 = 75.7
[tex]\tt 4807=3500\times c\times 75.7\\\\c=0.018~J/g^oC[/tex]
If a wave of red light has a wavelength of 6.7 x 10-7 m, will the frequency of the red wave be high or low?
Answer:
Its high
Explanation:
Becuase if u times it what do u get
Surface water is found in oceans, lakes, reservoirs, streams, rivers,and glaciers. Lakes, rivers, and reservoirs are where humans obtain most of the surface water they use. Aquifers are an underground source of water that humans also use.
What is a system?
A. An isolated piece of the world
OB. A liquid in which reactions take place
O C. A piece of scientific equipment
O D. A technique for recording data
Answer:
D. a technique of recording data
choose the letter that best describes the behavior of a substance during a phase change:
/A/ neither absorbs or releases energy
/B/ always absorbs energy
/C/ always releases energy
/D/ either absorbs or releases energy
Answer:
/D/ either absorbs or releases energy
Explanation:
During a phase change energy is either absorbed or released.
A phase change is a reversible process which occurs when a substance changes is its state from one form to another.
Phase changes are used to delineate physical changes.
A phase diagram provides a graphic representation of the change. The diagram can be 2 dimensional or 3 dimensional.Do you guys have viruses wit this website
ANSWER ASAP PLEASE!!
What determines how many of each ion is required for an ionic compounds?
please do not look up on google!!!!
Each ion has a single charge, one positive and one negative, so we need only one ion of each to balance the overall charge. When writing the ionic formula, we follow two additional conventions: (1) write the formula for the cation first and the formula for the anion next, but (2) do not write the charges on the ions.
Help ASAP!!!! Plz!!!!!!!
Which describes the elements in a given group of the periodic table?
They decrease in atomic mass as you go down the column.
They increase sequentially in atomic number from top to bottom.
They are in the same family, with similar characteristics.
Their properties change according to a pattern as you go down the column.
Answer:
They are in the same family, with similar characteristics.
Explanation:
The elements in a given group of the periodic table are in the same family and with similar characteristics.
Vertical columns on the periodic table are referred to as a group or family. Elements having the same number of electrons in the outermost shell of their atoms are placed one another in vertical columns. Each resulting vertical column is a group or family. Elements in the same group exhibit similar chemical properties because of the same number of electrons in their atoms' valence shells.Volcanic belts form along
a.
islands in the Pacific Ocean.
b.
North American mountain ranges.
c.
the boundaries of Earth’s plates.
d.
the coast of Antarctica.
Please select the best answer from the choices provided
You are conducting an experiment with two very reactive substances. One will react with oxygen (O) and other substances in the air, and the other will react to metal in a container. What type of environment can you seal them in so they only react with each other?
Answer:
seal them in a glass container in an atmosphere of argon (Ar) gas
Explanation:
What is the mass of 0.250 mol of chlorotrifluoromethane, CCIF3?
A. 26.1 g
B. 104 g
C. 4.78 x 10-3 g
D. 52.2g
Answer:
26.1g
Explanation:
Cclf3
=35.5
F=54/101.5
Mass=mol*mm
=0.25*1015
=26.1g
Is a backpack a good resource
for a rescue team?
How many moles are in a sample of 2.39 x 10^23 atoms of sodium (Na)
Answer:
The answer is 0.4 molesExplanation:
To find the number of moles in a substance given it's number of entities we use the formula
[tex]n = \frac{N}{L} \\ [/tex]
where n is the number of moles
N is the number of entities
L is the Avogadro's constant which is
6.02 × 10²³ entities
From the question we have
[tex]n = \frac{2.39 \times {10}^{23} }{6.02 \times {10}^{23} } \\ = 0.39700996...[/tex]
We have the final answer as
0.4 molesHope this helps you
Which refers to a method that relies on sound waves and is used by different animal species for navigation,
communication, and finding food?
echolocation
analog signaling
infrared detection
o digital location
HELP FAST ILL MARK BRAINLEST
Answer:
A
Explanation:
got it on edge
An echolocation refers to a method that relies on sound waves and is used by different animal species for navigation, communication, and finding food. Therefore, option A is correct.
What is an echolocation ?Echolocation is a method used by bats, dolphins, and other animals to locate objects using reflected sound. This enables the animals to move around in complete darkness, allowing them to navigate, hunt, recognize friends and enemies, and avoid obstacles.
(1) To hunt for prey, bats make high-frequency sounds. (2) Sound waves are used by dolphins and other toothed whales to locate prey and navigate their surroundings. (3) Nocturnal oil birds use echolocation to navigate their surroundings, particularly in low-light conditions.
Echolocation is used to help with orientation, obstacle avoidance, food acquisition, and social interactions.
Thus, option A is correct.
To learn more about an echolocation, follow the link;
https://brainly.com/question/7828418
#SPJ6
During the Metric Olympics yesterday, Molly's long jump was 118.3 cm. Christy accidentally recorded her results in inches. She jumped 51.18 inches. Can you help... Who won the long jump? Christy won by about 30 cm Christy won by about 30 cm Molly won by about 25 cm Molly won by about 25 cm Christy won by about 12 cm Christy won by about 12 cm Molly won by about 10 cm
Answer: Christy won Molly by 12cm
Explanation:
Ist step
Molly's ;ong jump was 118.3cm
Christy long jump was 51.18inches
2nd Step
we change christy score to cm so we can compare
1 inch = 2.54cm.
therefore 51.18 inches = 51.18 x 2.54= 129.9972cm
Christy won molly by 129.9971cm-118.3cm=11.69 rounded to 12cm
Christy won Molly by 12cm
Why are biopharmaceuticals in high demand?
Answer:
the market is largely driven by the growing population, increasing burden of chronic disease, and rising inclination toward targeted therapy.
Explanation:
also, the huge demand of biopharmaceutical is facilitated by an accelerating focus in research and related investment.
Calculate the volume 3.00 moles of a gas will occupy at 24.0 °C and 762.4 mm Hg.
Answer:
Use formula of PV = nRT
Change formula to solve for Volume = nRT/P
R is a constant 0.08206
Convert C to Kelvin which is just +273
And turn mmHg into atm which is around 1 atm
Plug in and solve
Which has a smaller ionic radius than it's neutral atom?
A. Iodine
B.Cesium
C.Oxygen
D.Nitrogen
Explanation:
Caesium (Cs) has a smaller ionic radius than it's neutral atom.
because Caesium belong to Group 1 and It loses 1 electron. After losing 1 electron it gains 1 positive charge that's why caesium ionic radius become smaller as compared to neutral atom.
Therefore,
Option B is correct.
Calculate the heat that must be supplied to
a 532 , stainless steel vessel containing 375 g
of water to raise its temperature from 35 C
to the boiling point of water 100°C. Cs. =0.51 J/g. degrees C
Answer in units of J.
Q must be supplied = 119523.3~J
Further explanationThe law of conservation of energy can be applied to heat changes, i.e. the heat received/absorbed is the same as the heat released
Q in = Q out
Heat can be calculated using the formula:
Q = mc∆T
Q = heat, J
m = mass, g
c = specific heat, joules / g ° C
∆T = temperature difference, ° C / K
So from the question :
Q to the system(Q supplied) = Q water + Q steel vessel(Q gained)
[tex]\tt Q~supplied=m.c\Delta T(water)+m.c\Delta T(vessel)\\\\Q~supplied=375\times 4.18\times (100-35)+532\times 0.51(100-35)\\\\Q~supplied=101887.5+17635.8=119523.3~J[/tex]
Scientists and nutritionists have long suspected that high-fructose corn syrup, used to
sweeten soft drinks, is one of the causes of childhood obesity. In a recent study, at the
University of Cincinnati, researchers found that mice that drank water with added
fructose ate less solid food, gained more weight, and put on 90% more body fat than
mice that drank only water. Scientists concluded that fructose may affect metabolism in
a way that favors fat storage.
What is the independent variable?
The mice that drank only water
The presence of fructose in their diet
The quantity of water provided
The weight gained by the mice
Answer:
The presence of fructose in their diet
Explanation:
The independent variable in an experiment is the type of variable which is changed at intervals in order to study if it has a direct effect on the dependent variable.
The dependent variable in the experiment is the amount of weight gained by the mice in each group and the control group is the mice who drank the water without the fructose added.
If the density of a substance is 2.18 g/mL, how would you find the density given that the mass is 0.987 kg and the volume is 4.52 x 102 mL?
Answer:
Explanation:
Convert mass in gms .. 987 gms
Density = mass/ volume
= 987/4.52 x102
= 2.18 g/mL
How does the valence electron configuration (entire last energy level configuration) relate to the group number on the Periodic Table? Use the shorthand notation in your discussion.
Answer:
The valence electron configuration determines the group to which an element belongs to.
Explanation:
The valence electron configuration of an atom of an element refers to the number of electrons in that atoms outermost shell.
The valence electron configuration is related to the group number of an element in that the number of electrons in the valence shell of an atom of an element determines the group to which an element belongs to. For example, all elements having one valence electron belong to group IA of the periodic table. Similarly, all elements having seven valence electrons belong to group VIIA of the periodic table.
This is because, since the reactivity of an element is related to its ability to either gain or lose a certain number of electrons in its valence shell, elements having same number of valence electrons have similar chemical properties.
Neturally an atom is neutral in charge why
Answer
Explanation:
an atom is usually define as a perfect balance of electrons and protons
What kinds of paintings did Winslow Homer make
What occurs to the particles in a fluid during convection ?
Answer: what are options
Explanation:
What is the decomposition of 2LiCIO3
Explain three ways the periodic table is organized. Include in your essay the
definition of two listed trends and the patterns observed for each of your selected
trends on the periodic table
Answer:
The periodic table is organized in non-metals metals and metalloids, in in terms of trends and patterns you may want to talk about the the density of the elements or the mass of per unit of measurement of whatever you're going to use sorry that could be much help but I hope it helps.
2. Calculate the density of a rock that has a mass of 21.58 grams and causes the water in a
graduated cylinder to rise from 20.0yl to 25.4 ml.
Answer:
4.00 g/mL
Explanation:
Density is mass divided by volume (g/mL).
Mass of rock = 21.58
Volume of rock = 25.4 - 20.0 = 5.4mL
Density of rock = 21.58g / 5.4mL = 3.99629 g/mL
Round to the lowest number of significant figures which is three = 4.00 g/mL
You have a solution of water and pure ethanol. The boiling point of water is 100 degrees Celsius and the boiling point of pure ethanol is 78 degrees Celsius. A. What process would you would use to separate this solution? Describe, in detail, how this process works.
Answer:
Distillation
Explanation:
A solution of water and ethanol are miscible. Hence, they can only be separated by a process known as distillation. Distillation is the process in which two or more constituents in a mixture are separated based on there difference in boiling points. The mixture is subjected to high heat and the one with the least boiling point distills/evaporates out first followed by the next least boiling point.
From the explanation above, it can be deduced that ethanol (with boiling point of 78°) will be distilled out while water remains in the boiling tube or container.
In reality, energy conversion from burning fuel is never 100% efficient. Significant loss of energy due to heating occurs. If the generator were only 20% efficient (which is more realistic), how much energy in joules would be converted to electrical energy and how much would be lost to heat? (2 points)
Answer:
Electrical energy = 130000000 J and Heat energy = 520000000 J
Explanation:
Multiply the amount of joules from the last question (650000000) by .20 and .80. (Which are the percentages)