what is the anwser to this question

Answer:

Answer is A

Explanation:

Increase in wind

Most animals obtain their nutrients by the consumption of other organisms. At the cellular level, the biological molecules necessary for animal function are amino acids, lipid molecules, nucleotides, and simple sugars. However, the food consumed consists of protein, fat, and complex carbohydrates.

Answer:Most animals obtain their nutrients by the consumption of other organisms. At the cellular level, the biological molecules necessary for animal function are amino acids, lipid molecules, nucleotides, and simple sugars. However, the food consumed consists of protein, fat, and complex carbohydrates.

Explanation:

Answer:

All the matter that is made of atoms that cannot be broken or beaten into thin sheet .2All matters of a given book are in mass and mixture

Answer:

ok

Explanation:

Answer:

On the pereiodic table.

Explanation:

Answer:All matter can move from one state to another. It may require extreme temperatures or extreme pressures, but it can be done. Sometimes a substance doesn't want to change states. You have to use all of your tricks when that happens. To create a solid, you might have to decrease the temperature by a huge amount and then add pressure. For example, oxygen (O2) will solidify at -361.8 degrees Fahrenheit (-218.8 degrees Celsius) at standard pressure. However, it will freeze at warmer temperatures when the pressure is increased.

Some of you know about liquid nitrogen (N2). It is nitrogen from the atmosphere in a liquid form and it has to be super cold to stay a liquid. What if you wanted to turn it into a solid but couldn't make it cold enough to solidify? You could increase the pressure in a sealed chamber. Eventually you would reach a point where the liquid became a solid. If you have liquid water (H2O) at room temperature and you wanted water vapor (gas), you could use a combination of high temperatures or low pressures to solve your problem.

Points of Change

Phase Changes: Pressure and temperature define the state of matter for water.Phase changes happen when you reach certain special points. Sometimes a liquid wants to become a solid. Scientists use something called a freezing point or melting point to measure the temperature at which a liquid turns into a solid. There are physical effects that can change the melting point. Pressure is one of those effects. When the pressure surrounding a substance increases, the freezing point and other special points also go up. It is easier to keep things solid when they are under greater pressure.

Generally, solids are more dense than liquids because their molecules are closer together. The freezing process compacts the molecules into a smaller space.

There are always exceptions in science. Water is special on many levels. It has more space between its molecules when it is frozen. The molecules organize in a specific arrangement that takes up more space than when they are all loosey-goosey in the liquid state. Because the same number of molecules take up more space, solid water is less dense than liquid water. There are many other types of molecular organizations in solid water than we can talk about here.

CHEMISTRY TERM PHASE CHANGE

Fusion/Melting

Freezing

Vaporization/Boiling

Condensation

Sublimation

Deposition

Solid to a Liquid

Liquid to a Solid

Liquid to a Gas

Gas to a Liquid

Solid to a Gas

Gas to a Solid

Explanation:

Answer:

5 million

Explanation:

Answer:

Forming positive ions

Explanation:

A sodium atom has one electron in its outer shell. ... It will still have 11 positive protons but only 10 negative electrons. So, the overall charge is +1. A positive sign is added to the symbol for sodium, Na +.

Hope it helps

xoxo

Explanation:

Forming Positive Ions

Hope It Helped U

Answer:

D

Explanation:

I took a study island on this

Answer:

For a 1:100 dilution, one part of the solution is mixed with 99 parts new solvent. Mixing 100 µL of a stock solution with 900 µL of water makes a 1:10 dilution. The final volume of the diluted sample is 1000 µL (1 mL), and the concentration is 1/10 that of the original solution

Explanation:

i hope that gives you an idea

Formula of hydrated sodium carbonate : Na₂CO₃.10H₂O, so moles of water in one mole of hydrated salt = 10

Hydrate is a compound that binds water (H₂O), usually in the form of crystals/ solids

If these compounds are dissolved in water or heated, the hydrates can decompose:

Example: X.YH₂O (s) → X (aq) + YH₂O (l)

The formula for the hydrated compound contains: YH2O

The mole ratio shows the ratio of the coefficients of the hydrate compound

10.45 hydrated sodium carbonate(Na₂CO₃.xH₂O) were heated until 3.87 of 3.87of anhydrous (Na₂CO₃) remained, so

mass H₂O released :

[tex]\tt 10.45-3.87=6.58~g[/tex]

mass Na₂CO₃ = 3.87 g

mol ratio Na₂CO₃(MW= g/mol) : H₂O(MW=18 g/mol) =

[tex]\tt \dfrac{3.87}{105,9888}\div \dfrac{6.58}{18}=0.0365\div 0.3655=1\div 10[/tex]

Answer:

The correct answer is - rain.

Explanation:

At 32 degrees c or zero degrees Celsius, droplets of water in the atmosphere do not freeze as it is not the temperature at which water freezes but it is the temperature at which ice melts.

At this temperature the water changes its state, below 32 degrees Fahrenheit the water freezes but in the atmosphere, it not freezes necessarily and remains in the liquid state and called super-cooled liquid or water. Above this temperature, water in liquid state.

Thus, the precipitation is in the form of rain.

According to the concept of solubility,applying heat often speeds up the process of dissolving particles.

Solubility is defined as the ability of a substance which is basically solute to form a solution with another substance. There is an extent to which a substance is soluble in a particular solvent. This is generally measured as the concentration of a solute present in a saturated solution.

The solubility mainly depends on the composition of solute and solvent ,its pH and presence of other dissolved substance. It is also dependent on temperature and pressure which is maintained.Concept of solubility is not valid for chemical reactions which are irreversible. The dependency of solubility on various factors is due to interactions between the particles, molecule or ions.

Learn more about solubility,here:

https://brainly.com/question/9098308

#SPJ2

Answer:

A. The ratio of the element in glucose is different than in ethanol

Explanation:

The compounds given are;

      Glucose      C₆H₁₂O₆

     Ethanol         C₂H₆O

The two compounds given are different from one another. But they have the same elemental composition.

   Ethanol is made up of Carbon, hydrogen and Oxygen and so also, Glucose

Now,

  The number of atoms in both compounds are different;

                                   Number of atoms

                        C                             H                     O

Glucose           6                             12                      6

Ethanol            2                              6                       1

Answer:

1440g

Explanation:

Divide 504g by 0.350g

Answer:

0 kgm/s

Explanation:

The momentum of Bob while resting at the river is 0 kgm/s.

This is because the momentum of any object at rest is 0.

 Momentum is the quantity of motion a body contains. It is mathematically expressed as;

  Momentum  = m x v

m is the mass

v is the velocity

 So at rest, the velocity of a body is 0m/s and therefore, the momentum is O

Answer:

0.91m/s due west

Explanation:

Given parameters:

Time taken  = 17.2s

Displacement  = 15.6m

Unknown:

Velocity of the cart  = ?

Solution:

Velocity of a body is the the displacement divided by the time taken.

 Velocity  = [tex]\frac{displacement}{time}[/tex]  

Now insert the parameters and solve;

 Velocity  = [tex]\frac{15.6}{17.2}[/tex]  = 0.91m/s due west

Answer:

P(N₂) = 2.5 atm

Explanation:

Given data:

Total pressure of gasses = 6.7 atm

Partial pressure of O₂ = 3.0 atm

Partial pressure of CO₂ = 1.2 atm

Partial pressure of N₂ = ?

Solution;

According to Dalton law of partial pressure,

The total pressure inside container is equal to the sum of partial pressures of individual gases present in container.

Mathematical expression:

P(total) = P₁ + P₂ + P₃+ ............+Pₙ

Now we will solve this  problem by using this law.

P(total) = P(O₂)  + P(CO₂) + P(N₂)

6.7 atm = 3.0 atm + 1.2 atm + P(N₂)

6.7 atm = 4.2 atm + P(N₂)

P(N₂) = 6.7 atm - 4.2 atm

P(N₂) = 2.5 atm

Answer:

ooooooooooooooooooh i dont know this one

Explanation:

im not good a math at all

Answer:

22.4L

Explanation:

not sure if its totally correct but I tried

Answer:

I appreciate you- owo... and people do love you. uwu. even tho I am a stranger I love you :D. ❤

You're the best person anyone could ever ask for. Trust me you're enough <3

Answer:

117g

Explanation:

Given parameters:

Number of moles = 2moles

Unknown:

Mass of NaCl  = ?

Solution:

To solve the problem, we need to use the expression below;

    Mass of NaCl  = number of moles x molar mass

Molar mass of NaCl  = 23 + 35.5  = 58.5g/mol

So;

Insert the parameters and solve;

     Mass of NaCl  = 2 x 58.5  = 117g

Answer:

B.The Chocolate Chip Model

Explanation:

Answer:

hahahaha the soappp is dirty and the floor gets clean

Answer:

c

Explanation:

Answer:

the answer to your question is c