What are the half lives for uranium-235 and uranium-238?
a.
The half-life of uranium-235 is 713 seconds, the half-life of uranium-238 is 4.5 minutes
c.
The half-life of uranium-235 is 713,000,000 years, the half-life of uranium-238 is 4,500,000,000 years
b.
The half-life of uranium-235 is 713 days, the half-life of uranium-238 is 450 days
d.
None of the above

Answer:

6000pa

Explanation:

force= 2400N

area= 0.4m

pressure=?

now,

p= f/a

p= 2400/ 0.4

therefore,P=6000 pa.

Answer:

V=14

Explanation:

PE=KE

mgh=1/2mv^2

(2)(9.8)(10)=1/2(2)v^2

(radical) 196=(radical) v

V=14

Answer:

Unsaturated

Explanation:

the solubility of sodium nitrate is at 60 C is 124g/ml therefore, putting 100 grams will not saturate fully.

Answer:

when energy changes from one form to another, it always goes from a more useful to a less useful form. This means that people can't recycle or reuse high quality energy to perform useful work.

When energy changes from one form to another, it always transitions from a more helpful to a less useful one. Because of this, people are unable to reuse or recycle high-quality energy to complete crucial tasks.

Coal is most frequently and significantly used in combustion, where heat is produced to create steam, which in turn powers the turbines that generate electricity. All living things, including humans, are composed of carbon. However, as coal burns, its oxygen reacts with airborne oxygen to generate carbon dioxide. Although dioxide (CO2) is an odourless, colourless gas, it is one of numerous gases found in the atmosphere that can retain the heat from the planet.

It's a major issue for climate change since it produces more carbon dioxide when burned than oil or gas. In addition to producing microscopic soot particles and hazardous substances like arsenic and mercury, coal also contributes to air pollution.

To know more about Burning coal visit:

https://brainly.com/question/28813633

#SPJ2

Answer:

hello your question is incomplete hence I will give you a general answer on how a stunt cyclist performs his stunts successfully

answer ;

The stunt cyclist trying to perform some sort of stunt with the bicycle will be faced with some forces like the static fiction between the tires of the bicycle and wall and also a centripetal force.

In order to overcome the centripetal force the minimal grip of the bicycle must be equal to the weight and the speed at which the cyclist must go can be represented as :

[tex]V_{min} = \sqrt{\frac{r.g}{u} }[/tex]

Explanation:

The stunt cyclist trying to perform some sort of stunt with the bicycle will be faced with some forces like the static fiction between the tires of the bicycle and wall and also a centripetal force.

In order to overcome the centripetal force the minimal grip of the bicycle must be equal to the weight and the speed at which the cyclist must go can be represented as :

[tex]V_{min} = \sqrt{\frac{r.g}{u} }[/tex]

where ; r = radius of the tunnel where the stunt is to be performed

            g = gravitational speed

            u = coefficient of static friction

it absorbs all ligj colour except black

Answer:

your answer should be 48 m/s.

Explanation:

the total for was 30N and the formula for force is F=m*a divide the force by the known, in this case the mass. 30/0.625=48 m/s

Answer:

Mass is the measure of an object's matter (what it's made up of). The greater an object's mass, the greater its gravitational force. The earth has a strong attracting force for objects with smaller mass (including the moon), and the sun has an attracting force on the earth and other planets in our solar system.

Answer:

9 ohms

Explanation:

P = V²/R

R = v²/p = 6²/4 = 36/4 = 9 ohms.

The resistance is 9 Ohm.

To find the resistance, we need to know about the power in term of resistance and voltage.

Thus, we can conclude that the resistance is 9 Ohm.

Learn more about the electrical power here:

brainly.com/question/16054310

#SPJ2

Answer: This is what I found hope it helps

Explanation:

Answer:

H=Hydrogen, PO4=Phosphate

Explanation:

Reactions are on the left side of arrow and products are on the right side of arrow.

Answer:

Electrolytic manganese dioxide (EMD) is used in zinc-carbon batteries together with zinc chloride and ammonium chloride. EMD is commonly used in zinc manganese dioxide rechargeable alkaline (Zn RAM) cells also. For these applications, purity is extremely important.

Explanation:

hope this helps...

Answer:

two hr lead =90 miles

90/15=6hrs

2+6=8pm

Explanation:

Answer:

there's a center of the earth..and there is every later of it..just like in a movie...it is true

Answer:

The layers of rock at Earth ’s surface contain evidence of the evolutionary processes undergone by these components of the terrestrial environment during the times at which each layer was formed. By studying this rock record from the very beginning, it is thus possible to trace their development and the resultant changes through time.

Answer:

the answer is A because it has the least number but high in energy

The isotopes of any element have same number of protons inside them.

Cadmium is a chemical element with the symbol Cd and atomic number 48. It is soft, silvery and white metal.

Given is about Cadmium that it has eight naturally occurring isotopes.

Isotopes are the atoms of the same element which have same number of protons in them but the number of neutrons are different. Isotopes usually have same chemical properties, but they have different physical properties. Their can be stable and unstable isotopes. These unstable isotopes are also called radioisotopes, since they emit radiation. Thus, the isotopes have same number of protons.

Therefore, the isotopes of any element have same number of protons inside them.

To solve more questions on isotopes, visit the link below-

https://brainly.com/question/20596678

#SPJ1

Answer:

The water in a reservoir behind a hydropower dam is another example of potential energy. The stored energy in the reservoir is converted into kinetic energy as the water flows down a large pipe called a penstock and spins a turbine.

Explanation:

Hope this helps :))

A concrete dam holds back a large reservoir of water potential energy, the stored potential energy is converted into the kinetic energy which is converted into mechanical energy and then further converted into electrical energy.

A dam or other construction that alters the natural flow of a river or other body of water is used to generate hydropower, often known as hydroelectric power.

In order to generate energy, hydropower uses the perpetual, never-ending water cycle, which uses water as a fuel and leaves no waste products behind. Although there are many different kinds of hydropower plants, they are always propelled by the kinetic energy of water moving downstream.

Thus, a concrete dam holds back a large reservoir of water potential energy.

To learn more about hydropower here, refer to the link given below ;

https://brainly.com/question/22258411

#SPJ2

Explanation:

this is the answer for your question

Answer: 6V

Explanation: parallel circuit, the voltage is the same for each resistor.

Answer:

C

Explanation:

Hope this helps!

Answer:

True.

Explanation:

One can expect good quality produce if proper attention is given to the proper selection of planting materials.

Answer:

1s2,2s2,2p6 or (He) 2s2 2p6

Answer: 33N

Explanation:

Newton's second Law of motion F = ma

F = (0.6)(55) = 33N

Answer:

The pressure difference is equal to the product of density , height and g

Given that h is height difference between bottom and surface of a pool

P  

b

​  

−P  

s

​  

=dgh

Density d of water is 1

So we get P  

b

​  

−P  

s

​  

=gh

Therefore option A is correct

Explanation:

Answer:

Relative humidity depends on the amount moisture actually in the air at some temperature to the amount of moisture that the air can hold.

For instance, at 25 deg C the air has a saturation pressure of 23.76 mm of Hg.

That means that if at that temperature the pressure of the water vapor in the air reaches 23.76 mm Hg then the air is 100% saturated.

I believe the standard air pressure at 25 deg C is 760 mm Hg.

Now if the pressure of the water vapor in the air is 1/2 * 23.76 = 11.88 mm then the air is 50% saturated and the relative hunidity is 50 %.

At 100% relative humidity rain occurs (the air can't hold any more water).

When humidity is high, the chance of precipitation is high. The correct answer is b. When humidity is high, the chance of precipitation is high.

The amount of moisture or water vapor in the air is referred to as humidity. Relative humidity is a common way to measure it since it shows how much moisture the air is holding relative to how much it could contain at a particular temperature.

Any type of water that falls from the atmosphere and makes it to the surface of the Earth is referred to as precipitation. Examples include rain, snow, sleet, and hail.

When humidity levels are high, there is a lot of moisture in the air, which increases the possibility that saturation will occur. Excess water vapor condenses into visible water droplets or ice crystals as the air gets saturated, creating clouds. Condensed moisture in the clouds eventually gains enough weight to return to Earth as precipitation.

Therefore, when humidity is high, the chance of precipitation is high. The correct answer is:

b. When humidity is high, the chance of precipitation is high.

To know more about humidity, click here:

https://brainly.com/question/28528740

#SPJ6

Answer:

The ball would hit the floor approximately [tex]0.55\; \rm s[/tex] after leaving the table.

The ball would travel approximately [tex]5.5\; \rm m[/tex] horizontally after leaving the table.

(Assumption: [tex]g = 9.81\; \rm m \cdot s^{-2}[/tex].)

Explanation:

Let [tex]\Delta h[/tex] denote the change to the height of the ball. Let [tex]t[/tex] denote the time (in seconds) it took for the ball to hit the floor after leaving the table. Let [tex]v_0(\text{vertical})[/tex] denote the initial vertical velocity of this ball.

If the air resistance on this ball is indeed negligible:[tex]\displaystyle \Delta h = -\frac{1}{2}\, g\, t^{2} + v_0(\text{vertical}) \cdot t[/tex].

The ball was initially travelling horizontally. In other words, before leaving the table, the vertical velocity of the ball was [tex]v_0(\text{vertical}) = 0 \; \rm m \cdot s^{-1}[/tex].

The height of the table was [tex]1.5\; \rm m[/tex]. Therefore, after hitting the floor, the ball would be [tex]1.5\; \rm m \![/tex] below where it was before leaving the table. Hence, [tex]\Delta h = -1.5\;\rm m[/tex].

The equation becomes:

[tex]\displaystyle -1.5 = -\frac{9.81}{2} \, t^{2}[/tex].

Solve for [tex]t[/tex]:

[tex]\displaystyle t = \sqrt{1.5 \times \frac{2}{9.81}} \approx 0.55[/tex].

In other words, it would take approximately [tex]0.55\; \rm s[/tex] for the ball to hit the floor after leaving the table.

Since the air resistance on the ball is negligible, the horizontal velocity of this ball would be constant (at [tex]v(\text{horizontal}) =10\; \rm m \cdot s^{-1}[/tex]) until the ball hits the floor.

The ball was in the air for approximately [tex]t = 0.55\; \rm s[/tex] and would have travelled approximately [tex]v(\text{horizontal})\cdot t \approx 5.5\;\rm m[/tex] horizontally during the flight.

Answer:

the applied force is greater than the force of friction

Explanation:

pls give brainliest it makes me feel smart

Answer:

hi!

Explanation:

The answer is option b.

A box can definitely not move on it's own unless an external force is applied i.e muscular force. If the applied force would have been less than the force of friction then the box would have never displaced. But, since the box is able to move, we can imply that, the applied force is greater than the frictonal force leading in the displacement of the box.

ears

Explanation:

I want to eat your ears