the answer is (a. 21
Answer:the answer it’s A) I just took the test on USATestPrep
Explanation:
What will happen to a balloon filled with air when you cool the balloon in ice
Answer:
the volume of balloon decreases by the lower temperature because the gas inside is cool downBig sound is heard in bathroom than in a living room
Answer
That doesn't make any sense.
Explanation:
How many electrons per second flow through a wire with a 12pA current?
what allows electrons to move through it easily
Answer:
materials that allow many electrons to flow freely are caused conductors such as copper, silver, aluminum, hydrochloric solution, sulfuric acid, and salt water. in contrast materials which allow few electrons to flow are called insulators such as plastic, rubber, glass, and dried paper.
Explanation:
Hope this helped Mark BRAINLEST!!
Calculate the pressure exerted by the two straps of a handbag that has a force of 15N, and covers an area of 0.5cm2 (each)
Answer:
Pressure = 3000N/m²
Explanation:
Given the following data;
Force = 15N
Area = 0.5cm² to meters = 0.5/100 = 0.005m²
To find the pressure;
Pressure = Force/area
Substituting into the equation, we have:
Pressure = 15/0.005
Pressure = 3000N/m²
Aunt Mary needs to hang a picture in her bedroom. She uses a hammer to drive the nail into the wall. Find the force exerted by the hammer on the nail if the hammer stays in contact with the nail for 0.5s and has an impulse of 25Ns
Answer:
50N
Explanation:
Impulse = Force × Time
25 = Force × 0.5
Force = 25/0.5
= 50N
6. The transfer of thermal energy by radiation does not require matter.
O True
O False
Answer:false
Explanation:
A constant friction force of 21 N acts on a 63-kg skier for 25 s on level snow. What is the skier’s change in velocity?
Rain and wind place which type of load on structures?
A) Dynamic load
B) Soft load
C) Gradual load
D) Static load
A 0.225 kg sample of tin initially at 97.5°c is dropped into 0.115 kg of water. the initial temperature of the water is 10.0°c. if the specific heat capacity of tin is 230 j/kg • °c, what is the final equilibrium temperature of the tin-water mixture
Answer:
The final equilibrium temperature of the tin-water mixture is approximately 18.468 °C
Explanation:
The parameters of heat energy transfer from the tin to the water are given as follows;
The mass of the sample of tin, m₁ = 0.225 kg
The initial temperature of the tin, T₁ = 97.5 °C
The mass of the water into which the tin is dropped, m₂ = 0.115 kg
The initial temperature of the water, T₂ = 10.0 °C
The specific heat capacity of tin, c₁ = 230 J/(kg·°C)
The specific heat capacity of water, c₂ = 4,200 J/(kg·°C)
Let 'T' represent the final equilibrium temperature of the tin-water mixture, we have;
The heat lost by the tin, ΔQ[tex]_{tin}[/tex] = The heat gained by the water ΔQ[tex]_{water}[/tex]
∴ ΔQ[tex]_{tin}[/tex] = ΔQ[tex]_{water}[/tex]
Where;
ΔQ[tex]_{tin}[/tex] = m₁·c₁·(T₁ - T)
ΔQ[tex]_{water}[/tex] = m₂·c₂·(T - T₂)
By substitution, we have;
ΔQ[tex]_{tin}[/tex] = 0.225 kg × 230 J/(kg·°C) × (97.5°C - T)
ΔQ[tex]_{water}[/tex] = 0.115 kg × 4,200 J/(kg·°C) × (T - 10.0°C)
From ΔQ[tex]_{tin}[/tex] = ΔQ[tex]_{water}[/tex], we have;
0.225 kg × 230 J/(kg·°C) × (97.5°C - T) = 0.115 kg × 4,200 J/(kg·°C) × (T - 10.0°C)
∴ 5,045.625 J - 51.75 J/°C × T = 483 J/°C × T - 4,830 J
5,045.625 J + 4,830 J = 534.75 J/°C × T
∴ 534.75 J/°C × T = 9,875.625 J
T = 9,875.625 J/(534.75 J/°C) = 18.4677419 °C ≈ 18.468 °C
The final equilibrium temperature of the tin-water mixture, T ≈ 18.468 °C.
The illustration shows the forces in Newtons (N) acting on three different blocks. Which
boxes will move under these conditions?
Answer:a
Explanation:because I know
Answer:
B & C
Explanation:
the first block will not move
A bullet at 800 m/s horizontally hits a target that is 180m away. How far does the bullet fall before it hits the target?
which of the following correctly describes the hierarchy of genetic material within a cell
Answer: D- Each chromosome in a cell is made up of two chromatids, which are each made up of molecules of DNA
Explanation:
A macromolecule is a large molecule that is made of many smaller units. Chromosomes are macromolecules that contain all of the genetic information in a cell. Chromosomes are each made of two smaller units called chromatids. Chromatids are each made up of molecules of DNA. Therefore, the correct description of the hierarchy of genetic material in a cell is that each chromosome in a cell is made up of two chromatids, which are each made up of molecules of DNA. The structures become more and more microscopic as one moves down the hierarchy.
who was the chairman of drafting committe
Identify the medium an electromagnetic wave travels the fastest in.
empty space or vaccum the Electro magnetic wave travels the fastest.
How many degrees are there between the direction of motion and the force of friction?
A. O
B. 270
C. 90
D. 180
The correct option is (d).
Angle should be 180° between the direction of force and the direction of motion of a body as work done is equal to force multiplied by displacement multiplied by cosx.
Friction is a force that opposes motion. When two objects are in contact, friction is acts in a direction opposite to the motion of the object.A force known as friction prevents relative motion between surfaces that are in touch. One of the more basic features of friction is that it always runs parallel to the surfaces with which it makes contact and opposes any motion or attempted motion of the systems with respect to one another.What is the direction of friction force?When a force is applied to stop it from moving, frictional force provides resistance. As a result, it always moves in the opposite direction of an item in motion. Friction acts on the right when force is applied to the left.Learn more about direction of friction force brainly.com/question/24322020
#SPJ2
a variable that is changed by the researcher is called ___
the breakdown of rocks by chemical action of air and water is called
Answer:
Chemical weathering
Explanation:
This changes the molecular structure of rocks and soil. For instance, carbon dioxide from the air or soil sometimes combines with water in a process called carbonation. This produces a weak acid, called carbonic acid, that can dissolve rock.
A skydiver falls out of a plane from rest, and experiences no air resistance. Eventually, this skydiver reaches a velocity of 33 m/s. How much time did this take? *
Answer:
the time taken for the motion is 3.37 s
Explanation:
Given;
initial velocity of the skydiver, u = 0
final velocity of the skydiver, v = 33 m/s
The time taken for the motion is calculated as;
v = u + gt
33 = 0 + 9.8t
33 = 9.8t
t = 33 / 9.8
t = 3.37 s
Therefore, the time taken for the motion is 3.37 s
This image shows layers underground.
Top to bottom: Soil, Clay, Rocks, Granite.
Which layer will become saturated first when rain falls?
clay
granite
rocks
soil
Answer:
soil
Explanation:
CORRECT
Answer:
soil
Explanation:
Hope this will help
what hapenes to the wavelength of a wave if the frequency of the wave is increased?
Answer: The number of complete wavelengths in a given unit of time is called frequency (f). As a wavelength increases in size, its frequency and energy (E) decrease. From these equations you may realize that as the frequency increases, the wavelength gets shorter. As the frequency decreases, the wavelength gets longer.
Explanation:
how do you increase the ideal mechanical advantage of an inclined plane?
Answer:
The mechanical advantage increases as the slope of the incline decreases. But the load will then have to be moved a greater distance. The ideal mechanical advantage (IMA) of an inclined plane is the length of the incline divided by the vertical rise, the so-called run-to-rise ratio.
Explanation:
PLEASE MARK ME AS BRAINLIEST
Describe the Geocentric Model of the our solar system.
Answer:
its basically our universe
Explanation:
:) hope this helps
The adult house fly lives for only about 1 month, or 8 x 10^-2 y. The oldest recorded age of a tortoise was 1.8800 x 10^2 y. What is the difference between these two ages?
187.92 years
8*10^-2= .08
1.88*10^2= 188
188-.08=187.92
How would the model change as the atom forms bonds? The third shell would have eight electrons after the atom gains seven electrons to fill the outermost shell. The third shell would be empty so that the eight electrons in the second level would be outermost after the atom loses one electron. The first and third shells would be empty so that the atom would have eight electrons in its remaining shell after the atom loses three electrons. The first shell would have two electrons and the second shell would have six electrons after the atom loses three electrons.
Answer:
The third shell would be empty, so the eight electrons on the second level would be the outermost after the atom lost one electron
Explanation:
When an atom is bonded with other atoms, a more stable configuration must be reached, which is why the energy of the molecule is less than the energy of the individual atoms, for this to happen in general, electrons are shared or lost and gained in each atom, depending on the electronegative of the same.
If we analyze an atom within the molecule, its last shell is full, in the case of atoms with few electrons in this shell, they are lost and in the case of many electors in this shell, it gains electrons to have eight (8) in total.
When reviewing the different answers, the correct one is:
* The third shell would be empty, so the eight electrons on the second level would be the outermost after the atom lost one electron
Answer: It’s B
Explanation:
A rock is thrown horizontally off a cliff with an initial velocity of 15 m/s. How high was the cliff if the rock lands 22 m from the base of the cliff?
Answer:
22 m
Explanation:
Answer:
cliff height = 10.55 m
Explanation:
Remarks
This is one of those questions that defies belief. The final vertical velocity is the same as if you just dropped the rock, which is amazing.Another amazing fact is that the horizontal speed has no acceleration. And amazing fact number three is the the vertical initial speed is 0.And finally, the time taken to go horizontally = time to go vertically.Solution
Time
So the time taken is d = r * t
Remember, this formula can only be used when there is no acceleration.
d = 22 meters
r = 15 m/s
t = ?
t = d / r
t = 22 / 15
t = 1.467
Height of the Cliff
vi = 0 (vertially)
a = 9.8 m/s^2
t = 1.467 seconds The time horizontally and vertically is the same.
d = ?
Formula
d = vi*t + 1/2 a t^2
Solution
d = 0 + 1/2 * 9.8 * 1.467^2
d = 10.55 meters.
HELP MEEEEEEEEEEEEEEEEE
Answer:
I'm pretty sure it's half
Answer:
half
Explanation:
.................................
PLEASE HELPPPPP!!!!!!!!!
A 15 n net force is used to move a 5kg box. What is the resulting acceleration?
A. 15m/s^2
B. 5m/s^2
C. 20m/s^2
D. 3m/s^2
Answer:3 m/s
Explanation:
The resulting acceleration to move the 5Kg box is equal to 3m/s². Therefore, option (D) s correct.
What is acceleration?Acceleration can be defined as the rate of change in the velocity of an object with respect to time. The acceleration of an object is a vector parameter with both magnitude and direction. Acceleration is also defined as the first derivative of the velocity w.r.t. time and the second derivative of position w.r.t. time and
According to Newton's 2nd law of motion, the force is equal to the product of the mass (m) and acceleration.
F = ma
And, a = F/m
Therefore, the acceleration (a) inversely proportional to the mass (m).
Given, the force used to move the box, F = 15 N
The mass of the given Box, m = 5 Kg
The resulting acceleration, a = 15/5 = 3 m/s²
Therefore, the acceleration of the box is equal to 3 m/s² when it is pushed with a force of 15 N.
Learn more about acceleration, here:
brainly.com/question/3046924
#SPJ5
A 14-gauge copper wire of diameter 1.628 mm carries a current of 12.5 What is the potential difference across a 2.00 - m length of the wire? *p=1.47x10^-8
Answer:
[tex]V=1.76\times 10^{-4}\ V[/tex]
Explanation:
Given that,
The diameter of a wire, d = 1.628 mm
Radius, r = 0.814 mm = 0.000814m
Current, I = 12.5 mA
The length of the wire, l = 2m
The resistivity of the wire, [tex]\rho=1.47\times 10^{-8}\ \Omega-m[/tex]
We need to find the potential difference across the wire. We know that the resistance of the wire is given by :
[tex]R=\rho\dfrac{l}{A}[/tex]
Also, V = IR
[tex]\dfrac{V}{I}=\rho\dfrac{l}{A}\\\\V=\dfrac{\rho l I}{A}\\\\V=\dfrac{1.47\times 10^{-8}\times 2\times 12.5\times 10^{-3}}{\pi \times (0.000814)^2}\\\\V=1.76\times 10^{-4}\ V[/tex]
So, the potential difference of the wire is [tex]1.76\times 10^{-4}\ V[/tex].