Answer:
40
Explanation:
I'm not sure
Why are metals sometimes added to gold?
to make it softer and more malleable
to improve the value of gold
to raise its melting point
to make gold stronger and more durable
Please help to complete this
Whats the different between chemical property and chemical change, and physical property and physical change?
Answer:
I think the answer is A physical property is a characteristic of a substance that can be observed or measured without changing the identity of the substance. Physical properties include color, density, hardness, and melting and boiling points. A chemical property describes the ability of a substance to undergo a specific chemical change.
Explanation:
I hope this helps.
Answer:
Physical change is the same substance, while a chemical change is a new substance.
What can form along faults when pushed together or pulled apart?
O Mountains
O Volcanoes
O Both
Answer:
Both
Explanation:
if you pull a mountain a part that would be great consequences and if a volcano breaks there will be fire .
What are electron Subshells?
Answer:
a subshell is a subdivision of electron shells that are separated by electron orbitals.
Explanation:
(subshells are labeled s,p,d, and f in an electron configuration)
giving brainly if correct and explained
Answer:
D.
Explanation:
A concentrated solution is one that has a lot of solute (the substance being dissolved) in the solvent (the substance doing the dissolving). When a solution is concentrated, it means it has a high ratio of solute to solvent, so the answer is D.
Hope this helps.
a vessel contains 66 g co2 and 16 g o2 at a pressure of 10.0 atm. what is the partial pressure of co2?
This question is providing the masses of carbon dioxide and oxygen gases at 10.0 atm as 66 g and 16 g respectively, and is asking for the partial pressure of the former which turns out to be 7.50 atm after doing the math.
Thus, we can start solving this problem with the Dalton's law approach, in order to make a relationship for the total pressure, partial pressure and mole fraction, which means we must first determine the mole fraction of carbon dioxide gas in the mixture as shown below:
[tex]x_{CO_2}=\frac{n_{CO_2}}{n_{CO_2}+n_{O_2}}[/tex]
Next, we calculate the moles of both gases by dividing the grams over the molar masses:
[tex]n_{CO_2}=\frac{66g}{44.01g/mol} =1.50mol\\\\n_{O_2}=\frac{16g}{32g/mol} =0.5mol[/tex]
Then, the mole fraction of carbon dioxide as the required one by plugging in the previously calculated moles:
[tex]x_{CO_2}=\frac{1.5}{1.5+0.5}=0.75[/tex]
Finally, we use the definition of the Dalton's law to calculate the partial pressure of carbon dioxide gas in the binary mixture:
[tex]P_{CO_2}=x_{CO_2}P\\\\P_{CO_2}=0.75*10.0atm\\\\P_{CO_2}=7.50 atm[/tex]
Learn more:
(Dalton's law) https://brainly.com/question/14119417
Help me with my Science, Part 1 and 2 please this has to be done by tomorrow
Answer:
Part 1: Condensation is when - a
Condensation happens when- water vapour suddenly freezes
Part 2: Water, condenses, vapour, cold, droplets, Condensation
Consider the reaction below. Upper C upper C l subscript 5 (g) double-headed arrow upper P upper C l subscript 3 (g) plus upper C l subscript 2 (g). At 500 K, the reaction is at equilibrium with the following concentrations. [PCI5]= 0. 0095 M [PCI3] = 0. 020 [CI2] = 0. 020 M What is the equilibrium constant for the given reaction? 0. 042 0. 42 2. 4 24.
The equilibrium constant of the reaction is 0.042.
The reaction equation is given as;
PCl5(g) ⇄ PCl3(g) + Cl2 (g)
Recall that this equation shows the decomposition of phosphorus pentachloride.
We have the following equilibrium concentrations;
[PCI5]= 0.0095 M
[PCI3] = 0.020
[CI2] = 0.020 M
The equilibrium constant, K is obtained from;
K = [PCI3] [CI2]/[PCI5]
K = [0.020]^2/[0.0095]
K = 0.042
Learn more: https://brainly.com/question/17960050
which of the following molecular compounds does NOT need the usage of prefix for the first element
SO2
S2O3
N2S
N2S3
Answer:
SO2
Explanation:
that's my answer
Sana mKatolong
What is the volume in mL of 1 Kg of gold? The density of gold is 19.3 g/mL.
Answer:
Volume occupied is approx.
38 ⋅ ML
Explanation:
Density ρ = Mass Volume And thus Volume = Mass ρ = 1.592 ⋅ l b × 454 ⋅ g ⋅ l b − 1 19.3 ⋅ g ⋅ m L − 1 = ? ? ⋅ m L
Enter the correct ground-state (or lowest energy) configuration based on the number of electrons: 1s^2 2s^2 2p^6 3s^2 3p^6 3d^10.
Answer:
FIGURE 5.9 The arrow shows a second way of remembering the order in which sublevels fill. Table 5.2 shows the electron configurations of the elements with atomic numbers 1 through 18.
Element Atomic number Electron configuration
sulfur 16 1s22s22p63s23p4
chlorine 17 1s22s22p63s23p5
argon 18 1s22s22p63s23p6
Explanation:
Brainlilest me
 Write the chemical compounds and names for the following ionic compounds. Magnesium and phosphorus 
Answer:
Magnesium is Mg.
Phosphorus is P.
State charles's law. If a balloon occupies 885 cm3 volume at 20°C and 794 cm3 at - 10°C , prove that this is according to charles's law.
find the distance between
the following points:
a) AC0₂0) and B(5, 2)
in 1-2 sentences explain how the shorelines can affect weather.
Answer: Global warming causes sea-level rise as oceans expand, and makes storm patterns more energetic. Consequently it will affect most of the world's coastlines through inundation and increased erosion.
Explanation:
Is a graph that starts at 25 and drops to 21, stays the same in temperature an endothermic reaction or an exothermic reaction?
Answer:
Explanation:
Endo and Exo thermic are defined by what changes take place in the environment of the reaction.
If the temperature goes up, the reaction is giving up heat. It is Exothermic.
If the temperature goes down, the reaction requires heat. It is Endothermic.
In this case, the temperature went down. The reaction is Endothermic.
the sun`s blank is the layer that emits visible light
Answer: photosphere.
Explanation:
The part of the Sun commonly called its surface is the photosphere. The word photosphere means "light sphere" – which is apt because this is the layer that emits the most visible light. It’s what we see from Earth with our eyes.
If 12.7 grams of hydrogen reacted with an unknown amount of oxygen, how many grams of water would be produced? (Write a balanced equation and show your work under the equation)
Answer:
2H2 + 1 O2 ------> 2H2O
m = 12.7g m = ?
Get the number of moles for Hydrogen gas (H2) by dividing the mass by the molar mass (1.01g/mol as listed in the periodic table for its atomic mass)
12.7/1.01 = 12.57 mol of H2
Now use the mole to mole ratio of Hydrogen gas (H2) and water (H2O).
From the balanced equation, we can see that 2 mol of H2 gives us 2 mol of H2O. Since both of the ratios are equal (2:2), the moles we have for hydrogen gas is the same as the moles we get for water.
12.57 mol of H2O
Now that we have the amount of mol for H2O produced in this reaction, we can convert it to grams by multiplying the moles by the molar mass.
Molar mass of H2O = (1.01 x 2) + (16) = 18.02g/mol
12.57 x 18.02 = 226.5g (rounded)
Therefore 226.5g of water will be produced in this reaction
According to law of conservation of mass and stoichiometry, 114.3 g of water are produced if 12.7 grams of hydrogen reacted with an unknown amount of oxygen.
What is law of conservation of mass?According to law of conservation of mass, it is evident that mass is neither created nor destroyed rather it is restored at the end of a chemical reaction .
Law of conservation of mass and energy are related as mass and energy are directly proportional which is indicated by the equation E=mc².Concept of conservation of mass is widely used in field of chemistry, fluid dynamics.
2 H₂ + O₂[tex]\rightarrow[/tex] 2 H₂O,according to this equation,4 g hydrogen reacts with 32 g oxygen to give 36 g water, thus 12.7 g of hydrogen will produce 12.7×36/4=114.3 g water and hence for this amount of water to be formed 12.7 g of hydrogen reacts with 101.6 g of oxygen which is obtained as 114.3-12.7=101.6 g
Thus, 114.3 g of water is produced.
Learn more about law of conservation of mass,here:
https://brainly.com/question/28711001
#SPJ2
What is the mass of 3.2 L of water in centigrams?
what is the chemical formula for Salt and hydrogen gas?
Which of the following is the correct chemical symbol for Aluminium?
A: AL
B: Al
C: aL
D: al
What effect do shiny metals have on radiant energy?
Answer: Metals conduct heat and reduce the kinetic energy within the components that need to remain cool.
Explanation:
Pls fast pls due today pls pls I don’t wanna fail
Answer:
2:true
3: true
4:false
5: true
Explanation:
what is the strongest interparticle force in a sample of so2?
Answer:
The strongest intermolecular force in sulfur dioxide is dipole-dipole forces.
Explanation:
The interparticle force in [tex]SO_{2}[/tex] (sulfur dioxide) is the dipole-dipole interaction.
What is dipole-dipole interaction?
Dipole-dipole interaction is a type of intermolecular force that occurs between polar molecules. Polar molecules have a permanent dipole moment, which means they have a partial positive charge on one end and a partial negative charge on the other end. This creates an electrostatic attraction between the partial charges of neighboring molecules. The stronger the dipole moment of a molecule, the stronger its dipole-dipole interaction will be with other polar molecules.
Dipole-dipole interactions are responsible for a variety of physical properties of substances, including their boiling and melting points. Substances with strong dipole-dipole interactions tend to have higher boiling and melting points than substances with weaker interactions. In addition, the strength of dipole-dipole interactions can affect solubility, as polar substances tend to dissolve better in other polar substances due to their ability to form dipole-dipole interactions.
Learn more about dipole-dipole interaction, here:
https://brainly.com/question/30510859
#SPJ2
In Natural selection, who/what makes the decision about which traits are desirable and get passed to future generations?
In Artificial selection, who/what makes the decision about which traits are desirable and get passed to future generations?
please help me with these two questions complete sentences please thank you! This is for 50 points and BRAINLIEST.
Answer:
Artificial selection, also called "selective breeding” is where humans select for desirable traits in agricultural products or animals, rather than leaving the species.
A force is a push or a pull under the right circumstances anything can exert a force push a notebook or some other object so that it slides across a table or desktop what force causes the notebook to start moving what force causes the notebook to stop moving?
Answer:
the force that you applied caused the notebook to move.the force applied on the notebook by the table causes it to stop moving. this is because after sometime the book uses up the force and later the force you applied is less than that of the force by the table.
How many grams of water are needed to absorb 456 J if its temperature goes from 22.7 to 98.3 Celsius?
The mass of water needed to absorb 456 J is 1.44 g
We'll begin by calculating the change in the temperature of the water.
Initial temperature of water (T₁) = 22.7 °C
Final temperature (T₂) = 98.3 °C
Change in temperature (ΔT) =?ΔT = T₂ – T₁
ΔT = 98.3 – 22.7
ΔT = 75.6 °CFinally, we shall determine the mass of the waterHeat absorbed (Q) = 456 J
Change in temperature (ΔT) = 75.6 °C
Specific heat capacity of water (C) = 4.184 J/gºC
Mass of water (M) =?Q = MCΔT
456 = M × 4.184 × 75.6
456 = M × 316.3104
Divide both side by 316.3104
M = 456 / 316.3104
M = 1.44 gTherefore, the mass of the water is 1.44 g
Learn more: https://brainly.com/question/15563205
What is the total amount of work done when Danny lifted 25 pounds of weight over 5 meters and applying 30- Newtons of Force?
Answer:
Definition and Mathematics of Work
Calculating the Amount of Work Done by Forces
Potential Energy
Kinetic Energy
Mechanical Energy
002 (part 1 of 2) 10.0 points
1.5 mol HCl and 3.7 mol NaOH react accord-
ing to the equation
HCl + NaOH → NaCl + H2O.
If the limiting reactant is HCl, calculate the
amount of NaCl formed.
1. 1.9
2. 2
3. 1.1
4. 1.5
5. 1
6. 1.8
7. 1.2
8. 1.3
9. 1.4
10. 1.7
Answer in units of mol.
mol,
Answer:
4) 1.5 mol
Explanation:
Well, the equation is already balanced and the mole to mole ratio of reactants and products are all 1. So if the limiting reactant is HCl and you have 1.5 mol, you do the mole to mole ratio with NaCl and since it is 1 to 1, there'd be 1.5 mol of NaCl.
What does an atom's period tell us?
Answer:
A horizontal row in the periodic table, which signifies the totoal number of electron shells in an element's atom.
Explanation:
Hope this helpss)):