Answer:
0.7L
Explanation:
Given parameters:
Initial volume V₁ = 0.4L
Initial temperature T₁ = 20°C = 20 + 273 = 293K
Final temperature = 250°C = 250 + 273 = 523K
Unknown:
Final volume V₂ = ?
Solution:
To solve this problem, we apply Charles's law.
It states that "the volume of a fixed mass of a gas varies directly as the absolute temperature if the pressure is constant".
mathematically;
[tex]\frac{V_{1} }{T_{1} } = \frac{V_{2} }{T_{2} }[/tex]
V and T are temperature values
1 and 2 are initial and final states;
Insert the parameters and solve;
[tex]\frac{0.4}{293}[/tex] = [tex]\frac{V_{2} }{523}[/tex]
V₂ = [tex]\frac{523 x 0.4}{293}[/tex] = 0.7L
What Happens When extra Solute is added to unsaturated ,saturated and supersaturated solution
of water is 36.0 g. If any more NaCl is added past that point, it will not dissolve because the solution is saturated. If more solute is added and it does not dissolve, then the original solution was saturated. If the added solute dissolves, then the original solution was unsaturated.
Describe the two types of mechanical energy
Answer:
Kinetic energy and potential energy
Explanation:
kinetic energy is when the energy is active and potential energy is when it is about to be active
Describe the current model of the atom. Name the parts of this model and describe each part.
Answer:
the electron cloud model is the current model of atom
Arrange the following in order of increasing atomic radius: Mg, Na, P, Si, and Ar.
Answer:
Ar, P, Si, Mg, Na
Explanation:
Ar=106pm
P=107pm
Si=111pm
Mg=141pm
Na=166pm
Na>Mg>Si>P>Ar is the order of increasing atomic radius.
What are elements?Elements are the simplest substances which cannot be broken down using chemical methods.
Atomic radii vary in a predictable way along or across the periodic table. The atomic radius increases from top to bottom in a group, and decreases from left to right across a period. Thus we can say that helium is the smallest element, and francium is the largest.
Ar=106pm
P=107pm
Si=111pm
Mg=141pm
Na=166pm
Hence, Na>Mg>Si>P>Ar is the order of increasing atomic radius.
Learn more about elements here:
brainly.com/question/1896898
#SPJ2
Fe (s) + Pb(NO3), (aq) —> ___
Type of reaction: _____
Answer:
lead , chemical
Explanation:
If the atomic number increases then the atomic radius should decrease right? So what’s wrong with my data
Answer:
Atomic radius increases by increasing the atomic number.
Explanation:
Atomic radius :
Atomic radius is the distance between nucleus of an atom to its outer most electronic shell.
Trend along group:
As we move down the group atomic radii increased with increase of atomic number. The addition of electron in next level cause the atomic radii to increased. The hold of nucleus on valance shell become weaker because of shielding of electrons thus size of atom increased.
As the size of atom increases the ionization energy from top to bottom also decreases because it becomes easier to remove the electron because of less nuclear attraction and as more electrons are added the outer electrons becomes more shielded and away from nucleus.
The given data show that the atomic number in increased from 4 to 88 it means atomic radius also increased from 1.53Å to 2.83Å. It means the given data is the elements of periodic table present in group. It is the data of 2nd group of periodic table.
Can someone help me click the picture
Answer:
A product
B coefficient
C script
D rectant
Which of the following is a CHEMICAL CHANGE?
A- Buttering Toast
B- Melting ice Cream
C-An egg gives off a rotten smell
D-sugar is dissolved into water
E- baking soda mixed with vinegar forms bubbles
F- boiling water forms bubbles
G-Iron turns red as it rusts
H-Iron turns red as it is heated
Answer:
G, but I think that theres more than one answer
How many molecules are in 210 grams of CO2?
Answer:
30 molecules
Explanation:
easy
7. Calculate the average atomic mass of bromine. One isotope of bromine has an atomic mass of 78.92amu and a relative abundance of 50.69%. The other major isotope of bromine has an atomic mass of 80.92amu and a relative abundance of 49.31%.
Answer:
Average atomic mass = 79.9 amu.
Explanation:
Given data:
Average atomic mass of Bromine = ?
Atomic mass of 1st isotope = 78.92 amu
Relative abundance of 1st isotope = 50.69%
Atomic mass of 2nd isotope = 80.92 amu
Relative abundance of 1st isotope = 49.31%
Solution:
Average atomic mass = (abundance of 1st isotope × its atomic mass) +(abundance of 2nd isotope × its atomic mass) / 100
Average atomic mass = (50.69×78.92)+(80.92×49.31) /100
Average atomic mass = 4000.45 + 3990.16 / 100
Average atomic mass = 7990.61 / 100
Average atomic mass = 79.9 amu.
Which is most likely the result of millions of metal atoms crowding together so that molecular orbitals become combined?
Answer:
(The Formation Of Bands In A Crystal)
The image shows particles of salt dissolved in water.
How will the arrangement of salt particles most likely change?
Salt particles will move toward the left through diffusion.
Salt particles will move toward the left through active transport.
Salt particles will move toward the right through diffusion.
Salt particles will move toward the right through active transport.
Answer: Hope it may help you
Explanation:
Diffusion can be defined as the movement of particles from a region where there a more concentration of solute to the region having less concentration of the solute.
Here, the salt particles will move from right side of the box to the left side of the box.
This is because the right side has more particle and the left side has less particles so they will move towards the left side.
Answer:
A
Explanation:
write the correct representation of an element x which contains 12 electrons and 16 neutrons
Answer:
²⁸Mg
Explanation:
12 electrons means it is a Mg;
A typical Mg has 12 neutrons, but this has 16 hence it must be an isotope with 4 extra neutrons.
Question 7
2 pts
(04.03 LC)
Which of the following steps can be used to identify a single replacement reaction? (5
points)
O Check whether the products are salt and water.
O Check if the ions of two compounds exchange places.
o Check if one element replaces another element in a compound.
Check whether the reactants are an acid and a base.
Answer:
d
Explanation:
check if one element replaces another element in a compound
The single replacement reaction can be identified when there has been the replacement of one element with another element in the compound. Thus, option C is correct.
The replacement reaction can be defined as the reaction in which the highly reactive element replaced the low reactive element in the reaction and forms a compound.
The reaction has been given as:
X + AY [tex]\rightarrow[/tex] AX + Y
The X has been highly reactive than Y replaces Y in the compound and forms the compound AX.
The single replacement reaction can be identified when there has been the replacement of one element with another element in the compound. Thus, option C is correct.
For more information about a single replacement reaction, refer to the link:
https://brainly.com/question/8625202
A 200.0-mL sample of helium gas is in a cylinder with a movable piston at 110 kPa and 275 K. The piston is pushed in until the sample has a volume of 95.0 mL. The new temperature of the gas is 310. K. What is the new pressure of the sample?
51.1 kPa
261 kPa
249 kPa
274 kPa
Answer:
P₂ = 261 KPa
Explanation:
Given data:
Volume of sample = 200 mL
Initial pressure = 110 KPa
Initial temperature = 275 K
Final volume = 95 mL
Final temperature = 310 K
Final pressure = ?
Solution:
Formula:
P₁V₁/T₁ = P₂V₂/T₂
P₂ = P₁V₁T₂ /T₁ V₂
P₂ = 110 KPa× 200 mL× 310 K /275 K × 95 mL
P₂ = 6820000 KPa / 26125
P₂ = 261 KPa
tell me about yourself
Answer:
Tell picture above is a sample of tell me about yourself
Which of these properties can be used to separate mixtures? - characteristic properties *
1. state of matter
2. mass
3. volume
4. boiling/melting point
5. density
6. conductivity
7. solubility
Answer:
Boiling/melting point
Explanation:
Some elements can’t handle the heat nor the cold, so they separate like oil & water.
Which of the following is a true difference between protons and neutrons?
a
the have different masses
b
they are in different locations in the atom
c
the proton identifies the atom and the neutrons does not
d
all of the choices are true
Answer:
D
Explanation:
C - chemical change
P- physical change
(Pls help me)
Answer:
Burning wood is a chemical change. Burning wood is an example of a chemical reaction in which wood in the presence of heat and oxygen is transformed into carbon dioxide, water vapour, and ash.
Baking an apple pie is a physical change because the apples in the pie start changing physically and the pie crust starts hardening and rising up.
Explanation:
what is the needed electrons for CLO3-
Question: How hot is the sun?
Answer:
5,778 K
Explanation:
increased amounta of carbon dioxide in Earth's atmosphere may lead to global warming. what might global warming then lead to
air temperatures increasing.
Which is most likely the result of millions of metal atoms crowding together so that molecular orbitals become combined?
The formation of bands in a crystal
Explanation:
- hope that helped :)
Which describes a covalent bond?
a. Formed by the sharing of electrons between atoms
b. Formed by the giving and taking of electrons between atoms.
c. Formed by the forces of gravity between atoms.
d. Formed by sharing protons and neutrons between atoms
Answer:
a
Explanation:
covalent bonds are bonds between two nonmetals where they share an electron :)
which is not a redox reaction?
a. Formation of ammonium sulphate from ammonia and sulphuric acid
b. formation of nitrogen monoxide from ammonia
c. formation of sulphuric acid from sulphur
d. formation of zinc from zinc sulphide
help me please
Answer:
D. formation of zinc from zinc sulphide
Explanation:
A redox reaction could be explained as an artificial reaction in which electrons are moved between two reactants partaking in it. This substitution of electrons can be recognized by examining the variations in the oxidation states of the reacting classes. The generation of hydrogen fluoride is an illustration of a redox reaction. We can crack the reaction down to investigate the oxidation and loss of reactants.
What data do scientists use to determine when a volcano might erupt?
Whoever gives me the right answer will get brainliest.
Answer:
seismographs
Explanation:
Scientists use seismographs that record the length and strength of each earthquake to try to determine if an eruption is imminent. Magma and gas can push the volcano's slope upward.
Select the conditions that are required for the formation of hurricanes. (Choose 3)
A: cold,cyclonic wind
B: deep ocean water
C: cold ocean water
D: warm,humid wind
E: warm ocean water
F: a strong cold front
Answer:
A: cold, cyclonic wind
B: deep ocean water
C: cold ocean water
E: warm ocean water
F: a strong cold front
You only need A, B, C, E, F not D because that for tornadoes buddy.
What is the difference between carbon-12, carbon-13, and carbon-14?
Answer:
Number of neutrons in the nucleus.
Explanation:
Mass number is protons plus neutrons. Protons do not change from isotope to isotope
what is the physical state of the fuel in a lighter?why happens if you press the lighter in order to let the fuel to flow out
Answer:
It is a liquid gas
Explanation:
The spark of the lighter starts the fire which is exposed to the liquid gas in the lighter
What separation method collects vapor
Answer:
evaporation and distilation
Explanation: