Answer:
I don't think there is any metal matches with this condition
(-15)+(-12)+14
how do u simplify
Answer:
-15-12-14=-13
Explanation:
we simplify by opening the bracket
Give the noble gas configuration of vanadium (V), atomic number 23
The noble gas configuration of vanadium (V), atomic number 23 will be [Ar] 3d34s2.
What is noble gas configuration ?The electron configuration of noble gases would be known as that of the noble gas configuration. The propensity of chemical elements to gain stability forms the foundation of all chemical reactions. Chemical formation frequently leads to an entire electronic configuration approximating a noble gas for several main group elements.
The atomic number of V = 23
The noble gas configuration = [Ar] [tex]3d^{3} 4s^{2}[/tex].
To know more about noble gas configuration
https://brainly.com/question/13933772
#SPJ3
Answer:
[Ar] 3d3 4s2
Explanation:
[Ar] 3d3 4s2
How does the human body build the complex
molecules it needs?
Dehydration synthesis reactions build molecules up and generally require energy, while hydrolysis reactions break molecules down and generally release energy. Carbohydrates, proteins, and nucleic acids are built up and broken down via these types of reactions, although the monomers involved are different in each case
Answer:
Dehydration synthesis reactions build molecules up and generally require energy, while hydrolysis reactions break molecules down and generally release energy. Carbohydrates, proteins, and nucleic acids are built up and broken down via these types of reactions, although the monomers involved are different in each case.
Explanation:
In dry climates, people often dig wells to find additional sources of water
to raise crops or feed livestock. Which of the following could be
significant negative effect on the environment cause by obtaining water
from the well?
Select one:
A: The digging will create air pockets in the soil.
B: Using the well could erode the soil and increased the risk for mountain
landslides.
C: Crushed rock and layers of soil might pile up where the well is dug
D: Using the well could lower the water table throughout the area.
Answer:
D i think, sorry if its wrong
Explanation:
Answer:
Using the well could lower the water table throughout the area.
Explanation:
i just took a test and this was the answer
1 In what type orbital are the outer electrons of the atoms of the elements of Group 1 (IA) and Group 2 (IIA)?
Answer:
s orbital
Explanation:
The elements of Group 1 (IA) and Group 2 (IIA) have one and two electrons in their outermost shells respectively.
For the elements in group Group 1 (IA), the general outer electron configuration is ns1. This last electron is accommodated within an s orbital.
For the elements in Group 2 (IIA), the two outermost electrons are accommodated in an ns orbital, hence the answer.
I need help with the question below:
[tex]PCl_5 = PCl_3+Cl_2 \\ [/tex]
Where PCl5 and PCl3 are gasses
In the above equation , Predict the effect of change in :
I. Temperature
ii. Pressure
iii. Removal of Chlorine
Answer:
1: As the temperature rises, the equilibrium moves towards the products
2: The higher the pressure, the higher the equilibrium goes to the reactants
3: By removing chlorine, the equilibrium moves towards the products
Can i titrate a solution of unknown concentration with another solution of unknown concentration and still get a meaningful answer
Answer:
No, I don't think so at least
Explanation:
In chemistry, you do calculations to find the concentration of a solution with another solution of KNOWN concentration. Without concentrations of either solution, were would you get values from? Where would you start? :3
You can not titrate a solution of unknown concentration with another solution of unknown concentration and still get a meaningful answer.
Titration involves the standardization of unknown solution using a standard solution. By this definition, titration must involve a standard solution.
Since the two unknown solutions are not standardized, we can never get a meaningful answer because we can not be able to perform any calculation unless we have a standard solution.
Learn more: https://brainly.com/question/2728613
Magnesium hydroxide is added to a solution of hydrochloric acid. A reaction occurs and magnesium chloride and water are formed. Testing the _______ would show that a reaction has occurred.
Answer:Magnesium (Mg) is a - reactant
Hydrogen (H2) is a - product
magnesium chloride (MgCI2) is a - product
hydrochloric acid (HCI) is a - reactant
Explanation: It’s in my notes
Why is the distance traveled between seconds 0 and 1 less than the distance traveled between 2 and 3 sceonds
Answer:
The ball speeds up
Explanation:
What does it mean to be limiting or excess? (Limiting Reactant)
Answer:
Find the limiting reagent by calculating and comparing the amount of product each reactant will produce. Balance the chemical equation for the chemical reaction. The reactant that produces a lesser amount of product is the limiting reagent. The reactant that produces a larger amount of product is the excess reagent.
Explanation:
hydrogen + copper(II) oxide= copper + steam, which substance is oxidized. explain your answers
What is the difference between speed and acceleration?
Please help :)
Answer:
Speed is how fast you are going at the moment but acceleration is how fast you are building up speed to get to a set point
Explanation:
How many grams of 5% barium hydroxide solution will be needed to react 2 moles of sulfur (IV) oxide?
Answer:
DONT PRESS THAT LINK IT IS VIRUS AND HACK
Explanation:
briskly meaning
thankew 人(◕ᴗ◕✿)❤️
to all who liked my answers
plsssssssssss flw
can anyone pls flw me who aren't flwing
plsssssssssss answer fast
Answer:
You need follower?
See it shows this in Laptop
I can't see who I am following it does itself
Briefly describe each of the suns layers. I’ll give brainless
Answer: The inner layers are the Core, Radiative Zone and Convection Zone.
The outer layers are the Photosphere, the Chromosphere, the Transition Region and the Corona.
Nuclear fusion of hydrogen in the core of the Sun produces tremendous amounts of energy that radiate out from the Sun.
The corona is the outermost layer of the Sun, starting at about 1300 miles (2100 km) above the solar surface (the photosphere). The temperature in the corona is 500,000 K (900,000 degrees F, 500,000 degrees C) or more.
The chromosphere is a layer in the Sun between about 250 miles (400 km) and 1300 miles (2100 km) above the solar surface (the photosphere). The temperature in the chromosphere varies between about 4000 K at the bottom (the so-called temperature minimum) and 8000 K at the top (6700 and 14,000 degrees F, 3700 and 7700 degrees C), so in this layer (and higher layers) it actually gets hotter if you go further away from the Sun, unlike in the lower layers, where it gets hotter if you go closer to the center of the Sun.
The photosphere is the deepest layer of the Sun that we can observe directly. It reaches from the surface visible at the center of the solar disk to about 250 miles (400 km) above that. The temperature in the photosphere varies between about 6500 K at the bottom and 4000 K at the top (11,000 and 6700 degrees F, 6200 and 3700 degrees C)
(phew! There you go!)
can someone answer this
Answer:
choice B
58Fe^2+
Explanation:
hope this helped
What is a fault, and how does the existence of faults support the theory of plate tectonics?
“Many of the objections are long standing but apparently unknown to many geophysicists, while some are peculiar to the new global tectonics. The conclusions drawn, in order of probability, are (1) the continents have almost certainly not moved with respect to each other; (2) convection is not active throughout the whole mantle; (3) even if convection is active in the upper mantle it cannot account for drift; (4) pole positions derived from paleomagnetism, and results of this method of investigation in its global form generally, are afflicted with an unknown cause of error and are in any case too inexact for drift reconstructions.”
(Wesson, 1972)
Help!!!
Is KOH soluble or insoluble in water?
Insoluble
Soluble
Answer: yes, it's soluble in water.
True or False. Chemical changes only rearrange the elements that are
already present.
True or False. The reactants and the products of a chemical equation
always have the same number of atoms.
Here's link to the answer:
tinyurl.com/wpazsebu
How many moles of sulfuric acid (H2SO4) are present in 500.0 mL of 0.15 M H2SO4 solution?
Answer:
Number of moles = 0.075 mol
Explanation:
Volume = 500.0 mL = 0.5 (Converting to L by dividing by 1000)
Molarity = 0.15 M
Number of moles = ?
The relationship between the quantities is given as;
Molarity = Number of moles / Volume
Number of moles = Molarity * Volume
Number of moles = 0.15 * 0.5
Number of moles = 0.075 mol
In a closed system for the reaction: A (g) + 2B (g) → AB₂ (g) The rate of the reaction increases when there is
A) an increase in pressure
B) an increase in the reaction vessel
C) a decrease in the concentration of A
D) an increase in surface area of A
Answer: D
Explanation: an increase in surface area of A
if common names does not exist how would be the world of organic compounds
Explanation:
I think the question is not complete
Which of the following is an example of kinetic energy?
Answer: A river flowing at a certain speed
Explanation: as water has certain velocity and mass.
the action force
According to Newton's third law of motion, a reaction force between two objects is
but in the opposite direction.
equal to
greater than
less than
Answer:
equal to - it's opposite but equal energy is the third law
Given the following balanced equation:
2KCIO3 --> 2KCI + 302
How many grams of potassium chloride are produced when 45.Og of potassium
chlorate are decomposed?
0 27.4
0.04
0 2.74
O 0.4
Answer:
0.04
Explanation:
How much energy is released when 67.04g of phosphorous is reacted with 10.20g of chlorine? ___ P + ___ Cl2 ___ PCl3 ΔH = -574 kJ
Answer:
26.78 kJ
Explanation:
To solve the problem, we have to first write the stoichiometric coefficients in the chemical equation:
2P + 3Cl₂ → 2PCl₃
With these coefficients, we have the same number of atoms of each chemical element on both sides: 2 atoms of P, 6 atoms of Cl.
According to the equation, 2 moles of phosphorous (P) react with 3 moles of chlorine (Cl₂), and 574 kJ of energy are released. We have to figure out which is the limiting reactant. For this, we convert the mass into moles by using the molar mass(MM):
MM(P) = 30.9 g/mol
67.04 g P/(30.9 g/mol) = 2.17 mol P
MM(Cl₂) = 35.4 g/mol x 2 = 70.8 g/mol
10.20 g Cl₂/(70.8 g/mol) = 0.14 mol Cl₂
Now, we multiply the actual moles of P (the amount we have for the reaction) by the stoichiometric ratio given by the chemical equation (3 mol Cl₂/2 mol P):
2.17 mol P x (3 mol Cl₂/2 mol P) = 3.25 mol Cl₂
To completely react 67.04 g P, we need 3.25 mol of Cl₂, and we have only 0.14 moles of Cl₂, so the limiting reactant is Cl₂.
Now, we use the limiting reactant to calculate the energy released from the reaction. The energy released per mole of Cl₂ is:
ΔH/(3 mol Cl₂) = -574 kJ/3 mol Cl₂= 191.3 kJ/mol Cl₂
Finally, we multiply the energy released per mole of Cl₂ by the number of moles of Cl₂ we have:
0.14 mol Cl₂ x 191.3 kJ/mol Cl₂ = 26.78 kJ
For the balanced equation shown below, how many moles of H2O will react with 9 moles of N2?
N2 + 4H2O --> 2H2O2 + N2H4
Answer:
36 mole of H20
Explanation:
N2 + 4H2O --> 2H2O2 + N2H4
H20 : N2
4 : 1
x : 9
cross multiplication
so,
= 9x4/1 = 36 mole of H20
I hope this helps a little bit.
Organisms that get energy by eating dead organisms are called *
scavengers
omnivores
herbivores
decomposers
Answer:
The Answer is A. Scavengers
Plants are living organisms that respond to stimuli, use resources for energy, grow and develop, are organized by cells, and reproduce. A. true B. false
Answer:
true
Explanation:
Answer:
b. trueeeeeeeeeeeeeeeeeeeeeeeeeeee
Radioactive decay occurs when the ____ decays
Answer:
nucleus i think
Explanation: